Remote System (CP-1TT System)

Remote System (CP-1TT System)

The Remote vehicle detection system (product code: CP-1TT) is used to trigger RF and Satellite transmitters for interface with wireless applications when vehicles are detected.

Two models are availRemote Detection Probeable: 9 volt and 12 volt. Most of the sensitive electronics are located in the sensor probe, leaving a small 2½ square inch external circuit board conformal coated for installation in an outdoor, weatherproof box.

Its sensor is buried beside a driveway or lane, hidden and vandal-proof. It only detects moving steel, eliminating false alarms caused by animals or blowing objects.

With relay time and probe sensitivity adjustments and the choice of N.O. and N.C. dry relay contacts, this is one of the most versatile and dependable remote vehicle detection systems available in the market today.

This product has been used successfully for over twenty years. Both the United States and Canadian governments rely on it in their homeland security, border patrol and forestry services.

American made and supported.

Remote System Features

  • Based on magnetometer technology
  • Sensor buried beside driveway, hidden and vandal-proof
  • Covers 12 foot wide driveway
  • Direct burial cable of sensor coated with polyurethane and spliceable for field repairs
  • Single zone system
  • Triggers most any RF and Satellite transmitter
  • Excellent for use with solar power
  • Two systems: 9 volt & 12 volt
  • Small circuit board for mounting in outdoor, weatherproof box
  • Under 60 micro-amps standby current
  • N.O. and N.C. relay contacts
  • Manual trip test button for diagnostic purposes
  • Transient suppression against lightning built in
  • RFI/EMF protection
  • Adjustable sensor sensitivity
  • Adjustable relay time
  • Five year warranty
  • Made and supported in the U.S.

Remote System Components

Five components are necessary to make up the Remote System:

1. CP-1 Sensor probe

2. CB-1TT output board (9 volt & 12 volt models)

3. Transmitter of your choice

4. Receiver of your choice

5. Outdoor, weatherproof box of your choice

Component description:

CP-1 Probe • CP-1 Sensor probe

Based on magnetometer technology, the CP-1 sensor probe detects movement in the earth’s magnetic field caused by moving steel. It will not detect animals, people or blowing objects. Wind and weather do not affect it. This makes it virtually false-alarm proof. Most of the sensitive electronics are located in this probe.

Typically, the CP-1 sensor probe should be buried 6-10 inches below ground, beside, and parallel to, the driveway or lane. It covers a 12′ wide driveway from the side. It has direct burial cable attached, making conduit unnecessary. The cable should be buried 3-6 inches underground, up to and into a weatherproof box that contains the output board.

The CP-1 sensor comes with 80′ of direct burial cable attached. The cable is polyurethane coated, making repair-splicing in the field possible.

CB-1 • CB-1TT output board

Two models of this board are available: 9 volt and 12 volt. It is a 2½ square inch board that should be installed in an outdoor, weatherproof box.

The CP-1TT output board has relay time and probe sensitivity adjustments and the choice of normally open and normally closed dry relay contacts.

• Transmitter and Receiver of your choice

These products are not supplied by Cartell, but we suggest you consider using Inovonics, Linear or a compatible product.

• Outdoor, weatherproof box

This product is not provided by Cartell. The weatherproof box should be attached above ground to a post, tree or sturdy object. Contents installed inside should include the CB-1TT output board, battery (9 volt or 12 volt), transmitter and receiver.

Remote System Technical Specs

Remote Tech Specs

Print Version