Wireless With Inovonics

Wireless With Inovonics

Cartell and Inovonics partner to offer a remote vehicle detection system. Except for a small amount of direct burial cable attached to a sensor probe, you can easily have a wireless solution.

SYSTEM REQUIREMENTS

1. Cartell CP-1TT-9V system (includes sensor probe and small output board)
2. Cartell CF-2C or CT-2B control unit; or CT-8 annunciator
3. Inovonics FA210 Analog Universal Transmitter. Note: this has been replaced with the digital version EN1210. Or choose the Inovonics FA250 Analog High Power Universal Transmitter, which has been replaced with the digital version EN1210W.
4. Inovonics FA401R Analog Receiver (has been replaced with EN4204R digital receiver)
5. 9 volt Alkaline or Lithium battery to power CP-1 output board
6. 12 volt battery to power Receiver in the home
7. Weatherproof plastic box
8. 500 – 1000 Ω, 1/4 watt resistor

INSTRUCTIONS – SENSOR PROBE, OUTPUT BOARD, BATTERY AND TRANSMITTER

Inovonics 11. See Figure 1.
Install the CP-1 probe beside a 12 foot wide driveway

2. See Figure 1.
Install the following in a weatherproof box:

  • CP-1 output board
  • Inovonics 29 volt Alkaline or Lithium battery
  • Inovonics Transmitter Model FA210 for shorter ranges or FA250 for longer ranges (which have been replaced with EN1210 or EN1210W respectively).

3. See Figure 2.
Hook the CP-1 probe, 9 volt battery and Inovonics Transmitter to CP-1 output board as seen in Figure 2.

4. On the CP-1 output board, turn the relay time potentiometer fully clockwise for maximum relay time.

INSTRUCTIONS – INTEGRATING DIRECTLY WITH AA-1 AUDIBLE DEVICE

See Figure 3.

Inovonics 3

1. Install a single channel Receiver in the home (Inovonics FA401R (new product number is EN4204R)).

2. Install a 12 volt D.C. power source near the Receiver

3. Connect positive power to Common contact of Receiver.

4. Connect negative power to annunciator’s GND (Ground) terminal.

5. Connect Receiver’s Normally Open contact to annunciator’s SON (Sonalert) terminal.

INSTRUCTIONS – INTEGRATING WITH CF-2C OR CT-2B CONTROL UNITS

See Figure 4.

1. InInovonics 4stall a single channel Receiver in the home (Inovonics FA401R (new product number is EN4204R)).

2. Install either a CT-2B (sound only) or CF-2C (sound and lights) control unit in the home near the Receiver.

3. Connect 12 volt D.C. power source to the Receiver.

4. Connect Receiver’s N.O. contact to terminal #10 on CT-2B or terminal #17 on CF-2C.

5. Connect Receiver’s Common contact to terminal #12 on CT-2B or terminal #19 on CF-2C.

6. In the place of the Cartell sensor probe, place a 500 -1000 ohm 1/4 watt resistor across terminals #10 & #12 on the CT-2B or across terminals #17 & #19 on the CF-2C.

Print Version